Standard topology for SMA attenuators?
I noticed the circuit topology is never mentioned in datasheets of SMA attenuators. Will they mostly use a standard one or do all companies use different "proprietary" ones?
I've never encountered any treatment of attenuator topology, but if someone off the street asked me to choose, I'd pick T over Pi, because series R up front does a better job of hiding non-idealities than shunt R. Think about it: a leading shunt R demands perfection in the transmission line leading up to it, while a series R devours imperfections both prior and forward.
Not sure what you mean by topology? If you mean Tee or Pi type you may be surprised that most are neither, relying instead on a 2D slab of resistor material (which ohms out properly as if it were Tee or Pi). The big trick is broadbanding techniques especially when trying to ground the shunt. I would need to find an old paper to explain this type of attenuator. Madengr should know.
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
How to properly torque a right angle SMA connector
Short and Open Standard in Calibration Kit
How to get a microstrip out from under a SMA connector?
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2021 Microwaves 101 Discussion Board